Command Protocol Reference Guide
A - 51
Description
This parameter causes the incoming call to be ignored. The incoming ring
tones will be silenced on the local side, but the remote caller will still hear ring-
ing. Taking the phone offhook when there is an incoming ignored call will
cause the incoming call to be answered.
phone_redial
Redial The Last Number On The Telephony Interface
Description
Setting this parameter causes the last number to be redialed on the telephony
interface. The last number is defined as all the digits that were dialed since the
telephony interface was last connected (see the phone_connect parameter). If
the telephony interface is not already connected, setting this parameter will
automatically connect it before dialing.
phone_reject
Reject an Incoming Call
Description
Setting this parameter causes the incoming call to be rejected. For the Sound-
Structure VoIP Interface, the call is rejected and immediately sent to
voice-mail. For the PSTN interface, the call is terminated by automatically
Argument Argument value
Channel Type Virtual Channel
Value Type Void
Read/Write Mode Write-Only
Phys Chans Analog Telephony Output, VoIP Telephony Output
Virt Chans Mono
Event Source No
Argument Argument value
Channel Type Virtual Channel
Value Type Void
Read/Write Mode Write-Only
Phys Chans Analog Telephony Output, VoIP Telephony Output
Virt Chans Mono
Event Source No