Command Protocol Reference Guide
A - 59
Description
This parameter controls whether or not the flash hook delay is determined by
the default pstn_country settings (0) or by the phone_flash_delay setting (1).
pstn_in_gain
PSTN Input Gain
Description
This parameter sets the gain (in dB) of the signal coming from the PSTN
interface.
Examples
pstn_line_voltage
PSTN Line Voltage
Argument Argument value
Channel Type Virtual Channel
Value Type Floating-Point
Read/Write Mode Read/Write
Phys Chans Analog Telephony Input
Virt Chans Mono
System Limits Minimum: -20.0, Maximum: 20.0, Resolution: 0.5
Default 0.0
User Limits
Supported
No
Event Source No
Command Response Description
set pstn_in_gain "Phone
In" 6
val pstn_in_gain "Phone
In" 6
Adjusts the input gain on the phone input to 6dB. Note
that the phone in virtual channel name must be used, not
the phone out virtual channel name.
Argument Argument value
Channel Type Virtual Channel
Value Type Integer
Read/Write Mode Read-Only
Phys Chans Analog Telephony Output
To Next Page
Loading...
Need help?
General
