Polycom Vortex EF2201 - Page 3

8.17. DELAYO -- Set Output Delay
8.18.
DELAYOE -- Enable Output Delay
8.19.
DIAL -- Send DTMF Digits to Phone Interface
8.20.
DSPAUTO -- Enable Automatic DSPLOAD Status Messages
8.21.
DSPLOAD -- Query Percentage of Variable DSP Resources Used
8.22.
ERROR -- Enable or Disable Error Messages
8.23.
FADERI -- Set Input Gain Fader
8.24.
FLASH -- Execute Hook Flash
8.25.
FLOW -- Set Flow Control Mode for RS-232 Port
8.26.
FPLOCK -- Lock/Unlock Front Panel
8.27.
FPPSWD -- Change Front Panel Password
8.28.
GAINA -- Set Phone Input Gain
8.29.
GAIND -- Set Gain of Incoming DTMF Tones
8.30.
GAINDIT -- Set Gain of Incoming DTMF Tones
8.31.
GAINDT -- Set Dial Tone Gain
8.32.
GAINI -- Set Input Gain
8.33.
GAINO -- Set Output Gain
8.34.
GAINP -- Set Phone Output Gain
8.35.
GAINSIT -- Set From Phone User Tone Gain
8.36.
GAINSOT -- Set To Phone User Tone Gain
8.37.
GMUTEO -- Mute All Outputs
8.38.
ID -- Set Device ID
8.39.
LABEL -- Set or Query one of the Device Labels
8.40.
LEC -- Enable or Disable LEC
8.41.
LECMODE -- Set Amount of Double Talk Suppression used in the LEC.
8.42.
LI -- Query State of Logic Inputs
8.43.
LIA -- Assign Action for when Logic Input is Activated
8.44.
LID -- Assign Action for when Logic Input is Deactivated
8.45.
LIH -- Assign Action for when Logic Input is Held
8.46.
LIEN -- Enable Automatic Logic Input Status Messages
8.47.
LIG -- Configure Logic Input Pins Into a Group
8.48.
LIK -- Delete One or All Logic Input Pin Commands
8.49.
LIM -- Mask Logic Input Pins
8.50.
LIN -- Assign Command to Logic Input Group
8.51.
LIP -- Set Polarity for Logic Inputs
8.52.
LO -- Query or Set Status of Logic Output Pins
8.53.
LOA -- Define Behavior for Logic Output Activated State
8.54.
LOD -- Define Behavior for Logic Output Deactivated Status
8.55.
LOEN -- Enable Automatic Logic Output Status Messages
8.56.
LOK -- Delete One or All Logic Output Pin Commands
8.57.
LOM -- Mask Logic Output Pins
8.58.
LOP -- Set Polarity for Logic Outputs
8.59.
MACROA -- Add Command to Current Macro
8.60.
MACROK -- Delete One or All Macros
8.61.
MACROL -- List All Commmands in a Macro
8.62.
MACROQ -- Execute Macro Quietly