Polycom Vortex EF2211 - AMLMM - Set Last MIC on Mode for Specified Automixer

This command is an integer command. See Section 6.2 for more information on this type of
command. The minimum and maximum values for this command are 0 and 5000, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01AMHOLD500
Set automixer hold time to 500
ms.
S01AMHOLD500
S01AMHOLD>500
Increase automixer hold time by
500 ms.
S01AMHOLDx , where x is between 0 and
5000 depending on the current AMHOLD
setting. If this command is issued after the
above example, then the status message will
be S01AMHOLD1000
S01AMHOLD?
Query automixer hold time.
S01AMHOLDx , where x is between 0 and
5000 depending on the current AMHOLD
setting. If this command is issued after the
above example, then the status message will
be S01AMHOLD1000
8.22. AMLMM -- Set Last Mic On Mode for Specified
Automixer
This command sets "last mic on" mode for the specified automixer. The first argument specifies which
automixer (always 1 on the EF2211) The second parameter specifies the operation of "last mic on"
mode and can be one of the following:
● 0 - last mic mode is off
● 1 - manual (use a specific mic)
● 2 - automatic (the last gated mic remains on)
Even though this is a channel integer command, use of the wildcard character for specifying the
automixer number is not supported.
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information
on this type of command. The minimum and maximum values for this command are 0 and 2,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message