Polycom Vortex EF2211 - MUTEGIL - Set Mute Status of Line Inputs as a Group

S01MMUTE1,*,0110100000
Set all crosspoint
mutes for input
channel 1. Mute the
paths from input 1
to outputs A, B, and
P and unmute the
paths from input 1
to outputs 1, T, R1,
and W-Z.
S01MMUTE1,*,0110100000
S01MMUTEA,*,0
Unmute all
crosspoints for input
channel A .
S01MMUTEA,*,0000000000
S01MMUTEA,*,2
Toggle all crosspoint
mutes for input
channel A .
S01MMUTEA,*,abcdefghij , where the value
of each of letters (a, b, etc.) is either 0 or 1
depending on the current state of each of the
crosspoint mutes. If this command was issued
after the example above, then the status
message would be
S01MMUTEA,*,0000000000
S01MMUTEA,*,?
Query all crosspoint
mutes for input
channel A .
S01MMUTEA,*,abcdefghij , where the value
of each of letters (a, b, etc.) is either 0 or 1
depending on the current state of each of the
crosspoint mutes. If this command was issued
after the example above, then the status
message would be
S01MMUTEA,*,0000000000
8.106. MUTEGIL -- Set Mute Status of Line Inputs as a
Group
This command sets the mute status of all the line inputs simultaneously. This is different from using a
wildcard, * with the
MUTEI command because that command sets all the mic and line inputs together,
while the MUTEGIL sets only the line inputs.
This command will generate acknowledgements from each of the line inputs separately.
This command is a boolean command. See Section 6.1 for more information on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01MUTEGIL1
Mute all line inputs.
S01MUTEIA1
S01MUTEIB1