Polycom Vortex EF2211 - LAGCRATE - Set Ramp Rate of Line Input AGC; LEC - Enable or Disable LEC

LAGCMIN is set to -10, then the AGC for that channel can apply a minimum of -10 dB of gain to the
input signal.
This command was introduced in firmware version 2.5.0.
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information
on this type of command. The minimum and maximum values for this command are -15 and 0,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01LAGCMINA-3
Set AGC minimum gain on input
channel A to -3 dB.
S01LAGCMINA-3
S01LAGCMINB?
Query the AGC minimum gain on
input channel B.
S01LAGCMINBx , where x is a number
between -15 and 0, depending on the
current setting of the AGC minimum gain on
input channel B.
8.72. LAGCRATE -- Set Ramp Rate of Line Input AGC
This command sets or queries the maximum rate at which the AGC can increase or decrease the gain
of the signals on input channels A-B. The ramp rate is expressed in dB/sec.
This command was introduced in firmware version 2.5.0.
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information
on this type of command. The minimum and maximum values for this command are 1 and 5,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01LAGCRATEA3
Set AGC ramp rate on input
channel A to 3 dB/sec.
S01LAGCRATEA3
S01LAGCRATEB?
Query the AGC ramp rate on input
channel B.
S01LAGCRATEBx , where x is a number
between 1 and 5, depending on the current
setting of the AGC ramp rate on input channel
B.
8.73. LEC -- Enable or Disable LEC