Polycom Vortex EF2211 - CGATET - Set Camera Gating Hold Time

This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01CGATEEN0
Disable automatic camera gating
messages.
S01CGATEEN0
S01CGATEEN1
Enable automatic camera gating
messages.
S01CGATEEN1
S01CGATEEN2
Toggle enabled state of automatic
camera gating messages.
S01CGATEENx , where x is either 0 or 1
depending on whether automatic camera
gating messages are currently disabled or
enabled.
S01CGATEEN?
Query enabled state of automatic
camera gating messages.
S01CGATEENx , where x is either 0 or 1
depending on whether automatic camera
gating messages are currently disabled or
enabled.
8.39. CGATET -- Set Camera Gating Hold Time
This command sets the hold time (in milliseconds) for the camera gating (CGATE) feature.
This command is an integer command. See
Section 6.2 for more information on this type of
command. The minimum and maximum values for this command are 100 and 5000, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01CGATET500
Set camera gating hold time to
500 ms.
S01CGATET500
S01CGATET>500
Increase camera gating hold time
by 500 ms.
S01CGATETx , where x is between 100 and
5000 depending on the current setting of
CGATET. If this command is issued after the
example above, the status message will be
S01CGATET1000 .
S01CGATET?
Query camera gating hold.
S01CGATETx , where x is between 100 and
5000 depending on the current setting of
CGATET. If this command is issued after the
example above, the status message will be
S01CGATET1000 .