Procedure
1. Call a contact.
2. When the contact answers, select the Conference soft key.
The call is held.
3. Enter another contact's number or select a contact from the directory or the call lists.
4. When the contact answers, select the Conference soft key.
All call participants are added to a conference call.
Join Calls to Create a Conference Call
You can join one active call and one held call into a conference call.
Procedure
1. Do one of the following:
• When you have an active call and a held call, select the Join soft key.
• When you have an active call and more than one held call, select a held call and then select
the Join soft key.
The active call and the selected held call are joined into a conference. If you have multiple held
calls, the other held calls on the line remain held.
End a Conference Call
By default, when you end a conference call, your connection to the call ends and the other participants in
the conference remain in the call.
However, your system administrator can set up your phone so that all connections terminate when you
end a conference call.
Procedure
1. During a conference call, select End Call.
Hold a Conference Call
When you place a conference call on hold, you place all conference participants on hold.
Procedure
1. Select Hold.
Resume a Conference Call
Resuming a held conference call enables all participants to hear the audio of everyone on the call.
Procedure
1. Select Resume.
Conference Calls
Polycom, Inc. 51
To Next Page
Loading...
