POLYtij S3i - 3.4.3 Printing Option

Edition: A03 September 6, 2018
37
Pre-purge: The user can choose to activate either double nozzles or the working nozzle. When
the Pre-purge function is ON, the printer will fire ink droplets at the desired setting level during idle
periods in the printing process. This will keep the nozzle plate warm and moist to eliminate the dried
ink phenomenon. Five levels to choose from: Close (off), Low, Middle, High, and Custom. At
separated mode you can set the P1, P2 pre-purge separately.
 Default setting is off.
 If selecting low, middle or high settings, pre-purge parameters will be set automatically.
 When setting to custom, the user can set the interval from 1 to 3600. For example, input
is 10 seconds. Then once selected ‘start printing’ and before the sensor signal, every 10 seconds
printer will spit some ink drops to keep the nozzles wet.
Object width：Input object’s width, then the pre-purge will not work between the setting
range. In separated mode you can set the P1, P2 object’s width separately.
Pre-print：When turning on this function，the printer will spray ink to wash the nozzles each
time an object is sensed. This function will only work in pre-purge mode.
3.4.3 Printing Option
Output Counter: Numbers already printed. User can set 0-999999999999.After modification
the counter will run based on the new value entered.
Counter Reset: Every time the user prints a message which contains a counter the system will
ask if you would like to reset the counter after printing. If selecting “Yes”, then from the next
printing counter it will run from the minimum value. If selecting “No”, the counter will continue
from the current value.
Print Cache: Message quantity is saved in system memory, value can be set from 1-20, if set to
1, it will print in real time.
Clean buff: When this function is set, once ‘start printing’ is selected the printer will clean
converted data and reconvert it. When this function is turned off, once ‘start printing’, the clean buff
button will hide. Default is closed.
3.4.4 Line setting
DPI: Printing resolution, ranges from 50-600.Default is 300.
Frequency: Turn on and set frequency to archive different DPI effects. E.g.: Connect 300 DPI
encoder, set frequency as 2, then the actual print effect is 150DPI.Set frequency as 3, then the actual
print effect is 100DPI.