POLYtij S3i - 5 Appendix 1: Terms and Definition

Edition: A03 September 6, 2018
57
The nozzle plate is delicate. Do not touch or clean nozzle with anything sharp or rough as not to
scratch nozzle.
Use the Non-woven cloth provided with the cartridge to wipe and clean the nozzle.
Note: Wipe the nozzle with the printhead facing down. Move the printhead in the direction of the
nozzle channel. Moving the printhead in the direction across the nozzle channel may damage the
nozzles.
Do not shake the ink cartridge or expose to extreme environments. Shaking or vibrating the cartridge
will allow air to run into the cartridge and affect the print quality.
To ensure best print quality, contact Digital Ink Technologies for further cartridge care instructions
specific to the ink being utilised.
5 Appendix 1: Terms and Definition
SN
Term
Description
Remark
1
Print delay
To adjust the distance from the time when
photocell detected the object till printing.
If you set delay distance as 30mm,
then it will start to print 30mm after the
photocell detects an object
2
Initial value
Initial start print value
For example, if you set initial value as
9, the first print value is 9
3
Time change
Users can set day switch time
When setting day switch as “08:00”
July 10, then the time is 07:59 July 09
for all printing before/on“07:59”
4
Pre-purge
To avoid printhead nozzles clogging
To avoid printhead nozzles clogging
5
Printhead cleaning
To clean the printhead
To clean the printhead
6
Nozzle switch
Switch nozzle to enable a better print result.
Switch nozzle to enable a better print
result.
7
Continuous printing
Multi-printing during the time from photocell begins
and ends
8
Screen saver time
Puts the screen in sleep mode to save electricity
power.
For example, if you set the screen
saver time as 0.5H, if the printer is not
operation within 0.5H, the screen will
be in sleep mode.