POLYtij S3i - 1 Important Precautions; Installation Precautions; Operation Precautions

Edition: A03 September 6, 2018
6
1 Important Precautions
Welcome to the high resolution POLYtij® S3i thermal inkjet printer. To protect the user’s personal safety
and user rights, please ensure correct installation and operation. Please read the following precautions
carefully and ensure anyone who will be using the machine is trained thoroughly using this manual.
Important Installation Precautions
 The recommended distance should be 0.5 – 2.5mm between the printhead and printing object.
 Make sure to insert or remove the ink cartridge from the print head at an angle of 15 degrees to
prevent damage to the cartridge.
 Do not place the printer in a dusty environment for extensive periods and please clean the printers
dust accumulation periodically.
 The printer can only use the original battery and charger provided by the manufacturer. Do not
open or put near or on open flames, and do not allow metal contact or electrode short circuit. Please
avoid placing in excessive heat (over 60 degrees Celsius), humid or corrosive environments.
Important Operation Precautions
 Do not poke or impact the touch screen with sharp materials.
 The built-in photocell should not be covered when in use, or the printer will not print.
 Please use the lint free cloth to wipe the nozzle plate when the print is not clear or dots are missing.
 When the printing position is changed, please set the printing delay to achieve the best printing
result.
 Do not insert or remove the ink cartridge while the machine is in printing process to not cause
damage to the cartridge or controller’s messages.
 Do not use compressed air for cleaning the touch screen. High pressure compressed air may
damage the touch screen.
 Do not use compressed air for direct or indirect cleaning of the ink cartridge. High pressure
compressed air may damage the nozzle plate.
Note: It is necessary for some cartridges to be removed from machine after operation. Turn off the
machine and remove the cartridge from the printer. Wipe the print head clean with a lint free cloth;
lock the print head with the protective cap to avoid the nozzles blocking (Contact our after-sale service
for more information about cartridges)