PORA PR-DTC-4100.AD - Digital Output; Filter

36
PORA ELECTRIC MACHINERY CO.,LTD.
Tension Controller
PR-DTC-4100.A / AD
12. DIGITAL OUTPUT
It is to set the items which will be used to digital output terminal.
13. FILTER
It is able to set delay time to tension indication and analog input/output signal.
1) TENSION(sec): It is to set delay time for tension indication.
- Setting range: 0.1 ~ 10.0
2) ANALOG IN(sec): It is to set delay time for analog input.
- Setting range: 0.1 ~ 10.0
3) ANALOG OUT(sec): It is to set delay time for analog output.
- Setting range: 0.1 ~ 10.0
※NOTE
When the motion of relevant data is severe, please adjust appropriate
value by going up slowly filtering time.
1. DIGITAL 1 2. DIGITAL 2
3. DIGITAL 3 4. DIGITAL 4
5. DIGITAL 5 6. DIGITAL 6
OUT ON/OFF
AUTO
TENSION ERRSENSOR ERR
ZERO
MANU
12. DIGITAL OUTPUT
ESC CLR SET SELECT
1) DIGITAL 1: It is to select the items which will be used to No. 1 digital
input terminal.
●
Select item: AUTO, MANU, OUT ON/OFF, ZERO, EMS, A/B, TENSION
HI, TENSION LOW, SENSOR ERR, TENSION ERR,
DIAMETER MAX
2) DIGITAL 2: It is to select the items which will be used to No. 2 digital
input terminal.
●
Select item: AUTO, MANU, OUT ON/OFF, ZERO, EMS, A/B, TENSION
HI, TENSION LOW, SENSOR ERR, TENSION ERR,
DIAMETER MAX
3) DIGITAL 3: It is to select the items which will be used to No. 3 digital input terminal.
●
Select item: AUTO, MANU, OUT ON/OFF, ZERO, EMS, A/B, TENSION HI, TENSION LOW, SENSOR ERR,
TENSION ERR, DIAMETER MAX
4) DIGITAL 4: It is to select the items which will be used to No. 4 digital input terminal.
●
Select item: AUTO, MANU, OUT ON/OFF, ZERO, EMS, A/B, TENSION HI, TENSION LOW, SENSOR ERR,
TENSION ERR, DIAMETER MAX
5) DIGITAL 5: It is to select the items which will be used to No. 5 digital input terminal.
●
Select item: AUTO, MANU, OUT ON/OFF, ZERO, EMS, A/B, TENSION HI, TENSION LOW, SENSOR ERR,
TENSION ERR, DIAMETER MAX
6) DIGITAL 6: It is to select the items which will be used to No. 6 digital input terminal.
●
Select item: AUTO, MANU, OUT ON/OFF, ZERO, EMS, A/B, TENSION HI, TENSION LOW, SENSOR ERR,
TENSION ERR, DIAMETER MAX
1. TENSION(sec) 2. ANALOG IN(sec)
3. ANALOG OUT(sec)
0.3
0.3 0.3
13. FILTER
ESC CLR SET SELECT