POWER ELECTRONICS SD450 - DEVICENET
SAFETY INSTRUCTIONS
9
ENGLISH
WARNINGS
RECEPTION
Material of Power Electronics is carefully tested and perfectly
packed before leaving the factory.
In the even of transport damage, please ensure that you notify
the transport agency and POWER ELECTRONICS: 902 40 20 70
(International +34 96 136 65 57) or your nearest agent, within
24hrs from receipt of the goods.
UNPACKING
Make sure received merchandise corresponds with delivery note,
models and serial numbers.
Each optional board is supplied with a technical manual.
SAFETY
Before operating the inverter, read this manual thoroughly to gain
and understanding of the unit. If any doubt exists then please
contact POWER ELECTRONICS, (902 40 20 70 / +34 96 136 65
57) or your nearest agent.
Wear safety glasses when operating the inverter with power
applied and the front cover is removed.
Handle the inverter with care according to its weight.
Install the inverter according to the instructions within this
manual.
Do not place heavy objects on the inverter.
Ensure that the mounting orientation is correct.
Do not drop the inverter or subject it to impact.
The SD450 inverters contain static sensitive printed circuits
boards. Use static safety procedures when handling these
boards.
To Next Page
Loading...
Need help?
General
