SD450 - DEVICENET POWER ELECTRONICS
24
OPERATION MODES
5.2. Explicit Message Connection (EMC)
established by Scanner
When the explicit message connection (EMC) is established by
scanner:
1. The NS led turns green. During this state, if EMC setting is
deactivated, NS led will turn green after 10 seconds delay. Once
EMC is connected, I/O connection setting is available. At this
time, the NS led will not change.
2. If I/O connection is not established within given time, then Time
Out will occur and the NS led turns flashing red (depending on the
time setting of EMC, the led can be changed to green again).
To Next Page
Loading...
Need help?
General
