5. Reinstall the Motor Controller, see "Motor Controller (MC) Replacement" on
page 107.
6. Plug
1
in the treadmill power cord and switch the power ON.
7. Clear the Error Lor or CPA
2
Event Log:
a. On P10, P30, P30i and P31 consoles:
Hold down the PAUSE key to access the Error Log and select OK to view error
codes. Use the UP/DWN keys to scroll thru the error codes. Hold down QUICK
START to clear all error codes.
b. P62, P80, and P82 consoles:
Access the Service menu (51765761) > About > CPA Event Log, select
REFRESH and then CLEAR to remove all error codes.
8. Press QUICK START to start a manual workout. Make sure the fan is running, that
the air flows into the MC housing, and there are no error code 14 events.
Note: The fan will only run after the running belt is moving.
9. Reinstall the hood cover, see "Hood Cover Replacement" on page 82.
10. Do the Operation Verification tests (see "Operation Verification" on page 23) and
return to service.
1
Device power cord connector or electrical cable male connector that is inserted into an
electrical receptacle "outlet" (also called the plug-in).
2
Touchscreen console Control Processing Assembly.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 124
6 Replacement Procedures
Motor Controller Fan Replacement
To Next Page
Loading...
Need help?
General