Establish snow groomer standby
Prerequisites
■ To prevent the vehicle from being set in motion unintentionally by the engine, the snow groomer
standby must also be activated for the vehicle's operational readiness.
■ Snow groomer standby can only be switched on under the following conditions:
□ The engine is running.
□ Both cab doors are closed.
□ The Emergency OFF switch is released.
□ The left steering console is down.
□ The steering levers are in the zero position.
□ The rotary switch for the engine speed setting is at zero.
■ In the following conditions, snow groomer standby is switched off automatically and must be
switched on again:
□ The engine has been switched off.
□ One of the cab doors has been opened.
□ The Emergency OFF switch has been pressed.
□ The left steering console has been raised.
Before starting off, the driver must make sure that there are no people or obstacles within the swivel
range of the vehicle and/or the tracks. Driver and passenger must always fasten their safety belts.
■ Use rocker switch S62 (1) on the control
console to activate snow groomer standby:
□
Press rocker switch upwards = snow
groomer standby ON
□ Press rocker switch downwards =
snow groomer standby OFF
Driving with steering levers
WARNING
Risk of skidding
The
snow groomer will change direction abruptly if the control lever is suddenly moved which may
cause the driver to lose control of the snow groomer.
► It is essential for the driver to be familiar with driving and steering the snow groomer before pre-
paring a ski slope.
► Never brake abruptly when descending a slope.
► Avoid uncontrolled manoeuvres at high vehicle speed.
► Both driver and passenger should always fasten their safety belts.
Operating and Maintenance Manual
Snow groomer BISON
116
(255)
8 - Driving
BISON 908930245 - 30367
8.6
8.7
To Next Page
Loading...