The automatic raising of the rear attachment can be switched off, e.g. for the mounting work. The de-
activation can be performed in the menu. The deactivation is signaled audibly by a warning tone.
Setting the tiller shaft speed
■ Set the cutter shaft speed with the rotary control (P).
The selected cutter shaft speed is shown on the display.
➽
See "Menu level "Operation"" (p. 93)
Setting the cutting depth
■ The cutting depth is set using push-button S1 and button T on the joystick.
The selected cutting depth is shown on the display.
➽
See "Menu level "Operation"" (p. 93)
Set the floating position / counter pressure / contact pressure
■ Press push-button S5 repeatedly to select the cutting mode (floating position/counter pressure/
contact pressure).
□
The selected mode is shown on the display.
□ If a setting is changed, it is saved until the engine is switched off.
Select the tiller shaft direction of rotation
■ The push-button A36/17 on keyboard 1 is used for selecting the tiller shaft direction of rotation.
➽
See "Keyboard 1" (p. 56)
Operating the side wings
■ The side wings are operated with the switches RS1/RS2 on the joystick.
When
the side wings are lowered, a time cycle is started, which repeats the action (lowering)
for 4 s every 30 min.
Snow chamber position indicator stick (Posiflex tiller only)
■ The snow chamber is operated with the switches S1 and T (up/down) on the joystick.
When
the snow chamber is closed, the orange indicator stick on the tiller is vertical. When the
snow chamber is opened, the indicator stick on the tiller is tilted toward the rear. Middle posi-
tions indicate that the snow chamber is partly closed or partly opened.
Snow groomer BISON
Operating and Maintenance Manual
BISON 908930245 - 30367
8 - Driving
121 (255)
■
■
■
■
■
■
To Next Page
Loading...