Pos. Name Image Description
■
If the warning lamp is continuously lit blue, the cool-
ant temperature is below 40°C (104°F).
19 Warning lamp Low oil
pressure
The warning lamp continuously flashes red when the ignition
switch
is in position 2 and the engine is at standstill. The warning
lamp should go off just after starting the engine. If the warning
lamp continuously flashes red while the engine is running, the
snow groomer must be stopped at a suitable place and the en-
gine turned off. There is a risk of engine damage.
20 Indicator lamp Engine
ECM fault
An engine electronics fault is indicated if the indicator light lights
yellow continuously.
21 Check indicator lamp for
Engine fault
An engine electronics fault is indicated if the indicator light lights
yellow continuously.
22 Warning lamp for battery
and charge control
The warning lamp should go out shortly after starting the engine.
If the warning lamp continuously flashes red when the engine is
running, the battery is no longer being charged. In this case,
check the drive belt, current generator and voltage regulator.
23 Indicator lamp Preheating
monitor
The indicator light lights up yellow continuously. The engine can
be started once this indicator lamp has dissapeared.
24 Error warning lamp If the warning lamp lights up red continuously, this indicates an
error.
If
the warning lamp lights up yellow continuously, this indicates a
fault.
Open menu item B.20 and identify the fault.
25 Parking light indicator
lamp
The parking light is activated if the indicator lamp lights up contin-
uously green.
If
the indicator lamp lights up yellow continuously, a fault in the
lighting system is indicated.
26 Full beam indicator lamp
27 Indicator lamp for rotating beacons
28 Locking the driver's cab If the warning lamp lights up, check locking of the driver's cab.
29 Indicator lamp to restore
snow groomer standby
These indicator lamps inform the driver about how to proceed to
put the snow groomer back into standby.
■
Re-engage the parking brake
■
Close the doors
■
Turn the engine speed rotary switch to MIN
■
Put the steering levers in neutral position
■
Put the steering console down (only when steering
levers are mounted)
■
Reduce accelerator pedal speed to MIN
Snow groomer BISON
Operating and Maintenance Manual
BISON 908930245 - 30367
6 - Display
79 (255)
To Next Page
Loading...