Chapter
Internet Management Thermostat Configuration Guide, Release 1.0 1-1
Part No. 600-03001-550, Rev. 1
Beta Draft Confidential
1
Overview
This chapter gives an overview of the Proliphix Internet Managed Thermostats (IMT)
Series Network Thermostats, as well as how to access the IMT550 using a Web
browser.
The IMT550 series of thermostats are powered by either Proliphix Ethernet Power
Adapters, Power over Ethernet, or via 24Vac from the HVAC system, and include the
following features:
DHCP Assigned IP Addresses
The IMT550c and IMT550w thermostat ship directly from the factory enabled to
perform as a Dynamic Host Configuration Protocol (DHCP) client. DHCP is an
established standard used to assign IP addresses automatically after each network
device is inserted into the network or when the device experiences a power cycle.
DHCP allows devices on your local network to receive their Internet Protocol (IP)
addresses automatically from an attached DHCP server typically located within a
local router.
If your file server or router supports DHCP, then your Proliphix thermostat
automatically retrieves an IP Address, Gateway Address, Subnet Mask, and DNS
server address from the DHCP server on your network.
Table 1-1 IMT550 Features
Model Wired
Ethernet
802.11 b/g
wireless
Humidity
Sensing
Aux Relays
(2)
Power
Method(s)
IMT550c X X X
EPA
PoE
HVAC
IMT550w X X X
HPA
HVAC
To Next Page
Loading...
