Proliphix IMT550c - Table 2-5 Alarms - Zone Field Descriptions

To Next Page

To Previous Page

Beta Draft Confidential

Alarms Page

Internet Managed Thermostat Configuration Guide, Release 1.0 2-21

Part No. 600-03001-550, Rev. 1

Use Table 2-5 to configure the Alarms - Zone page fields.

Table 2-5 Alarms - Zone Field Descriptions

Field Description

Zone Temperature Alarms

Low Temperature Limit Select a value or Disabled to indicate the low temperature

threshold detection status.

The value set by this parameter is monitored by the thermostat

and compared against the current Zone Temperature. If the

current Zone Temperature falls below this value, an alarm

condition is set and the status is displayed on the HVAC (page

2-2) page. In addition, this alarm is sent to the Proliphix web site

to trigger an e-mail notification, if the function is enabled, and

may also be sent as e-mail from this thermostat if configured on

Network - Notification Settings page. See E-mail configuration

on Network Notification Settings (page 2-42).

 Disabled (default) – No low temperature limit is set.

 -30

F(-34.5

C) to 200

F(93

This is a major (red) alarm condition.

Present for Enter how long the condition must be in effect before the alarm

is triggered. Note that the default is 0 minutes and the maximum

time allowed is 240 minutes.

High Temperature Limit Select a value or Disabled to indicate the high temperature