Proliphix IMT550c - Figure 2-24 Advanced - HVAC Settings Page - Heat Pump; Table 2-8 Advanced Settings Fields - HVAC Field Descriptions

Beta Draft Confidential
2-28 Internet Managed Thermostat Configuration Guide, Release 1.0
Part No. 600-03001-550, Rev. 1
CHAPTER 2: Configuring the Thermostat Using the Web Interface
Figure 2-24 Advanced - HVAC Settings Page
- Heat Pump
Use Table 2-8 to configure the Advanced Settings fields.
Table 2-8 Advanced Settings Fields - HVAC Field Descriptions
Field Description
HVAC System Type Select the type of HVAC system, either Fuel Burner (default) or
Heat Pump HVAC systems as follows:
 Fuel Burner (default) – The HVAC system burns fossil
fuels (e.g. gas or oil). Typically the system includes either an
oil or gas fired boiler or furnace. See Figure 2-23 on
page 2-27 and continue with If Your HVAC System is a Fuel
Burner (page 2-29).
 Heat Pump – Specifies that the HVAC system is based on
an electric compressor. See Figure 2-24 on page 2-28 and
continue with If Your HVAC System is a Heat Pump (page
2-30).