4. The measuring range limit of 0/4
mA and 20 mA can be adjusted by
raising and/or lowering the meas‐
ured values
ð
The limits of the measuring
range are adjusted in order to
calibrate the display tolerance
between the sensor or meas‐
uring device and the
DULCOMETER
®
D1Cb.
NOTICE!
Calibration
ProMinent also offers the possibility of
one-point or two-point calibration of
the "standard signal general" meas‐
ured variable. This calibration option
should only be used if the manufac‐
turer of the sensor or measuring
equipment describes or permits this in
the operating manual for the sensor
or measuring equipment.
Measured Variables and Operating Menus for the Standard Signal General
102
To Next Page
Loading...
