Proroute GEM420 - WDS Only Mode

Proroute GEM420 4G M2M Router
GEM420 User Manual 67
characters as the shared key. The key value is shared by the RADIUS server
and this router. This key value must be consistent with the key value in the
RADIUS server. The available encryption modes are “TKIP”, “AES”, or
“TKIP/AES”.
 WPA-PSK/WPA2-PSK
If some of wireless clients can only support WPA-PSK, but most of them can
support WPA2-PSK. You can choose this option to support both of them.
Select Encryption mode and enter the Pre-share Key. You can fill in 64
hexadecimal (0, 1, 2…8, 9, A, B…F) digits, or 8 to 63 ASCII characters as the
pre-share key. In this mode, you don’t need additional RADIUS server for user
authentication.
 WPA/WPA2
If some of wireless clients can only support WPA, but most of them can support
WPA2. You can choose this option to support both of them. Select Encryption
mode and enter RADIUS Server related information. You have to specify the IP
address and port number for the RADIUS Server, and then fill in 64
hexadecimal (0, 1, 2…8, 9, A, B…F) digits, or 8 to 63 ASCII characters as the
shared key. The key value is shared by the RADIUS server and this router. This
key value must be consistent with the key value in the RADIUS server.
Afterwards, click on “Save” to store your settings or click “Undo” to give up the
changes.
3.1.3.1.2 WDS Only Mode
While acting as a wireless bridge, Wireless Repeater 1 and Wireless Repeater 2 can
communicate with each other through wireless interface (with WDS). Thus all stations
can communicate each other.