Proroute GEM420 4G M2M Router
GEM420 User Manual 92
1. RIP: Routing Information Protocol (RIP) will exchange information about
destinations for computing routes throughout the network. Please select RIPv2
only if you have different subnets in your network. Otherwise, please select RIPv1
if you need this protocol.
2. OSPF: OSPF is an interior gateway protocol that routes Internet Protocol (IP)
packets solely within a single routing domain (autonomous system). It gathers link
state information from available routers and constructs a topology map of the
network. The topology determines the routing table presented to the Internet
Layer which makes routing decisions based solely on the destination IP address
found in IP packets.
To Next Page
Loading...