EasyManua.ls Logo

Pulse Secure MAG2600 - Service Modules and Management Card

Pulse Secure MAG2600
86 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAG Series Pulse Secure Gateways Hardware Guide
© 2016 Pulse Secure, LLC., All rights reserved.
21
The system raises an alarm if the fan fails or if the ambient temperature inside the chassis rises above the
acceptable range. If the temperature inside the chassis rises above the threshold temperature, the system
shuts down automatically.
You can check the status of fans and the chassis temperature from the Web interface if you have a chassis
management card (CMC) installed.
You cannot replace a single fan. If one or more fans fail, you must replace the entire fan tray.
NOTE: Faceplates are required for proper airflow and cooling. If you remove a chassis management card or
service module and do not intend to replace it, cover the opening with the supplied faceplate.
Integrated Access Service Modules
The MAG-SM160 and MAG-SM360 service modules provide SSL VPN connectivity, mobile device security and
management, and network access control (NAC). They can change personality so that administrators can
reconfigure from one mode of operation to another. For example, today the service module could be an NAC
module and tomorrow it could be set up as an SSL VPN. This allows for hardware reuse versus dedicated
hardware engine blades.
The MAG-SM160 and MAG-SM360 can be installed only in the MAG6610 and MAG6611.
The MAG-SM161 and MAG-SM361 service modules provide application acceleration platform in the data path
between a switch and a router.
Two service modules can be installed in the MAG6610 and four in the MAG6611 gateways. One service module
is installed in the MAG2600 and MAG4610.
The MAG-SM160, MAG-SM161, MAG-SM360 and MAG-SM361 service modules are paired with fan trays and
hard drives. When moving a service module to a different slot, you must move the associated fan trays and
hard drives to the new location as well.
A recessed reset button is located on the front of each service module and can be used to power on/off the
service module without having to power down the entire Pulse Secure Gateway.
NOTE: The MAG-SM360-PROFILER service module has similar hardware but is different from a MAG-SM360
service module. It is not an integrated service module. The MAG-SM360-PROFILER can be installed into a
MAG6610 or MAG6611 chassis. It has Great Bay Software Beacon Endpoint Profiler software preinstalled.
You cannot boot a different software image to change the personality of the MAG-SM360-PROFILER service
module.

Table of Contents