Grounded Equipment Warning
WARNING: The Pulse Secure Gateway is intended to be grounded. Ensure that the Pulse Secure Gateway is
connected to earth ground during normal use.
Midplane Energy Hazard Warning
WARNING: High levels of electrical energy are distributed across the Pulse Secure Gateway midplane. Be
careful not to contact the midplane connectors, or any component connected to the midplane, with any
metallic object while servicing components installed in the Pulse Secure Gateway.
Multiple Power Supplies Disconnection Warning
WARNING: The Pulse Secure Gateway has more than one power supply connection. All connections must be
removed completely to remove power from the unit completely.
Power Disconnection Warning
WARNING: Before working on the Pulse Secure Gateway or near power supplies, unplug the power cord from
an AC-powered Pulse Secure Gateway; switch off the power at the circuit breaker on a DC-powered Pulse
Secure Gateway.
TN Power Warning
WARNING: The Pulse Secure Gateway is designed to work with TN power systems.
Copper Conductors Warning
WARNING: Use copper conductors only.
DC Power Electrical Safety Guidelines and Warnings
When working with DC-powered equipment, observe the following guidelines and warnings:
•
DC Power Electrical Safety Guidelines
•
DC Power Disconnection Warning
•
DC Power Grounding Requirements and Warning • DC Power Wiring Sequence Warning
•
DC Power Wiring Terminations Warning
•
DC Power Electrical Safety Guidelines
The following electrical safety guidelines apply to a DC-powered Pulse Secure Gateway:
To Next Page
Loading...