Power and Cable Guidelines
Electrical Safety Guidelines and Warnings
In Case of Electrical Accident
If an electrical accident results in an injury, take the following actions in this order:
1.
Use caution. Be aware of potentially hazardous conditions that could cause further injury.
2.
Disconnect power from the Pulse Secure Gateway.
3.
If possible, send another person to get medical aid. Otherwise, assess the condition of the victim, and
then call for help.
General Electrical Safety Guidelines and Warnings
•
Install the Pulse Secure Gateway in compliance with the following local, national, or international electrical
codes:
•
United States—National Fire Protection Association (NFPA 70), United States National Electrical Code
•
Canada—Canadian Electrical Code, Part 1, CSA C22.1
•
Other countries—International Electromechanical Commission (IEC) 60364, Part 1 through Part 7
•
Evaluated to the TN power system
•
Locate the emergency power-off switch for the room in which you are working so that if an electrical
accident occurs, you can quickly turn off the power.
•
Do not work alone if potentially hazardous conditions exist anywhere in your workspace.
•
Never assume that power is disconnected from a circuit. Always check the circuit before starting to work.
•
Carefully look for possible hazards in your work area, such as moist floors, ungrounded power extension
cords, and missing safety grounds.
•
Operate the Pulse Secure Gateway within marked electrical ratings and product usage instructions.
•
For the Pulse Secure Gateway and peripheral equipment to function safely and correctly, use the cables and
connectors specified for the attached peripheral equipment, and make certain they are in good condition.
To Next Page
Loading...