5.
Follow the directions in the serial console, and enter the machine information for which you are
prompted, including the following:
•
IP address of the internal port (you configure the external port through the administrator Web console
after initial configuration)
•
Network mask
•
Default gateway address
•
Primary DNS server address
•
Secondary DNS server address (optional)
•
Default DNS domain name (for example, acmegizmo.com)
•
WINS server name or address (optional)
•
Administrator username
•
Administrator password
•
Common machine name (for example, connect.acmegizmo.com)
•
Organization name (for example, Acme Gizmo, Inc.)
After you perform the basic setup, you are ready to license the software, verify accessibility, and complete
the configuration process through the service module’s administrator Web console.
Changing the Service Module Personality
You can change your MAG2600, MAG4610, MAG-SM160 or MAG-SM360 personality at any time.
NOTE: Changing a service module’s personality deletes all configuration files and system and user data. You
must perform the basic setup again to reestablish network connectivity. The installation process may take
up to 20 minutes.
To change the service module personality from the serial console:
1.
Start a serial console session.
2.
Select option 4, System Operations.
3.
Select option 5, Factory reset.
To Next Page
Loading...