Powering Off
NOTE: After powering off a power supply, wait at least 60 seconds before turning it back on.
To power off the MAG2600, press the power button located on the front panel.
You can power off the MAG4610, MAG6610 and MAG6611 in one of the following ways:
•
Graceful shutdown—Press the Power button and hold it 3 to 5 seconds. The device begins gracefully
shutting down the operating system and then powers itself off.
•
Immediate shutdown—Press the Power button and hold it 15 to 20 seconds. The device immediately
powers itself off without shutting down the operating system.
The power button is located on the back panel of the chassis for the MAG4610, MAG6610 and MAG6611.
Pressing the power button on the MAG-CM060 powers off only the MAG-CM060.
•
Graceful shutdown—Momentarily press the Power button. The MAG-CM060 begins gracefully shutting
down the operating system and then powers itself off.
•
Immediate shutdown—Press the Power button on the MAG-CM060 and hold it 5 seconds. The MAG-
CM060 immediately powers itself off.
Using the Reset Button on the Service Modules
If an installed service module becomes unresponsive, you can use the Reset button to reboot that specific
module. Service modules operate independently, so that pressing the Reset button on one module does not
interfere with any other installed service module.
NOTE: The Reset button is recessed to prevent it from being pressed accidentally.
To press the Reset button, insert a small probe (such as a straightened paper clip) into the pinhole on the
front panel.
To Next Page