5.
Grasp the faceplate of the MAG-CM060, and align the notches in the connector at the rear of the MAG-
CM060 with the notches in the service module.
6.
Slide in the MAG-CM060 until it lodges firmly in the chassis.
7.
Tighten the thumbscrews until they are finger tight.
Connect the MAG-CM060 to a management console before powering up the Pulse Secure Gateway. Connect
a serial cable to the port labeled CONSOLE on the MAG-CM060 front panel, and connect the other end of
the serial cable to the serial port on the management device.
To Next Page
Loading...