To install the MAG-RK1U4 mounting tray in a rack:
1.
Have one person grasp the sides of the device, lift it, and position it in the rack.
2.
Align the bottom hole in each mounting bracket with a hole in each rack rail, making sure the mounting
rack is level.
3.
Have a second person install a mounting screw into each of the two aligned holes. Use a number-3
Phillips screwdriver to tighten the screws.
4.
Install the second screw in each mounting bracket.
5.
Verify that the mounting screws on one side of the rack are aligned with the mounting screws on the
opposite side and that the device is level.
To Next Page
Loading...