980 DP Video Generator - User Guide Rev. A4
Page 147 July 14, 2014
7.4 New Format - Digital Video Tab
The Format Editor Digital Video tab is shown below.
The table that follows describes each of the fields in the Digital Video tab.
Specifies the quantization range for the digital video. Parameter:
DVQM. The values available are described in CIA-861E:
0 - Full Range for computer applications.
1 – for testing the undershoot/overshoot signal code
margins.
2 – Limited range for reduced range required by television
standards.
Specifies the number of clocks per pixel (double clocking factor for
whole line. Parameter: NCPP. This parameter is used to boost the
clock rate to the minimum supported by TMDS interface. Allowable
values are:
To Next Page
Loading...