Quantum Data 980 DP - Main Control Panel

980 DP Video Generator - User Guide Rev. A4
Page 165 July 14, 2014
Network Analyzer – Dashboard Items
 Card –The Card area shows the current module whose port is being displayed on the Network Analyzer
. Currently the only analyzer module (card) is the 980 HDMI
Video Generator module.
 Port –The Port area shows the current Rx port that is being displayed on the Network Analyzer.
 . Currently the only analyzer port is the 980 HDMI Video Generator port.
Second Row Items:
 Lanes - The number of lanes used during link training.
 Bandwidth - The lane rate (per lane).
 Active (video resolution) - This is the measured video resolution.
 V Total - This is the measured total vertical video lines per frame.
Third Row Items:
 Res[olution] - The active video resolution in horizontal pixels and vertical lines determined
from the main stream attributes.
 Total (video) pixels and lines - The total video in horizontal pixels and vertical lines
determined from the main stream attributes.
 Sync - The number of horizontal pixels in the blanking and it polarity (e.g. 44 pixels, positive)
and the number of vertical lines in the blanking and its polarity (e.g. 5 lines, positive).
 Start - The starting pixel and line in the active video determined from the main stream
attributes.
 Colorimetry and bit depth - The colorimetry and bit depth determined from the main stream
atttributes.
 Scan - The scan type used, progressive (e.g. Prog) or interlaced (Inter) determined from the main
stream attributes.
Fourth Row Items:
 Sync -Clk - Indicates if the Link Clock and Main Video Stream clock are asynchronous or
synchronous. A value of N means async; a value of Y means synchronous. This value is determined by the
main stream attributes.
 Stereo-3D - The status of 3D audio determined from the main stream attributes.
 Mute - The AudioMute flag status determined from the main stream attributes.
 HDCP-Sync - The HDCP sync detect of the Video Blanking VB-ID bits. Y for sync detected; No
for HDCP sync not detected.
 Mvid - The Mvid value used for stream clock recover. This is determined from the main stream
atttributes.
 Nvid - The Nvid value used for stream clock recover. This is determined from the main stream
atttributes.
8.3 Main Control Panel
This subsection describes the main control panel for the Network Analyzer. Refer to the table below for a
description of these controls.