<id1>,<dir>,<stat>,<mode>,<mpty>[,<number>,<type>[,<
alpha>]]
[+CLCC:
<id2>,<dir>,<stat>,<mode>,<mpty>[,<number>,<type>[,<
alpha>]]
[...]
OK
If there is any error related to ME functionality:
+CME ERROR: <err>
<idx> Integer type. Call identification number as described in 3GPP TS 22.030 subclause
4.5.5.1. This number can be used in AT+CHLD command operation
<dir> 0 Mobile originated (MO) call
1 Mobile terminated (MT) call
<stat> State of the call
0 Active
1 Held
2 Dialing (MO call)
3 Alerting (MO call)
4 Incoming (MT call)
5 Waiting (MT call)
<mode> Bearer/tele service
0 Voice
1 Data
2 FAX
<mpty> 0 Call is not one of multiparty (conference) call parties
1 Call is one of multiparty (conference) call parties
<number> Phone number in string type in format specified by <type>
<type> Type of address of octet in integer format (refer to 3GPP TS 24.008 subclause 10.5.4.7 for
details). Usually, it has three kinds of values:
129 Unknown type
145 International type (contains the character “+”)
161 National type
<alpha> Alphanumeric representation of <number> corresponding to the entry found in phonebook.
To Next Page
Loading...
