Quectel EC25

LTE Module Series
EC25&EC21 AT Commands Manual
EC25&EC21_AT_Commands_Manual 40 / 231
4.3.1. AT+QCFG="gprsattach" GPRS Attach Mode Configuration
The command specifies the mode to attach GPRS when UE is powered on. This configuration is valid
only after the module is restarted.
+QCFG: “sgsn”,
(list of supported <sgsnr>s)
+QCFG: “msc”,(list of supported <mscr>s)
+QCFG: "pdp/duplicatechk",(list of supported <enable>s)
+QCFG: "tdscsq",(list of supported <value>s)
+QCFG: "urc/ri/ring",(list of supported <typeri>s),
(list of supported <pulseduration>s),
(list of supported <activeduration>s),
(list of supported <inactiveduration>s),
(list of supported <ringnodisturbing>s)
+QCFG: "urc/ri/smsincoming",
(list of supported <typeri>s),
(list of supported <pulseduration>s)
+QCFG: "urc/ri/other",
(list of supported <typeri>s),
(list of supported <pulseduration>s)
+QCFG: "risignaltype",
(list of supported <risignatype>s)
+QCFG: "urc/cache",
(list of supported <value>s)
+QCFG: "tone/incoming"
(list of supported <value>s)
OK
Maximum Response Time
300ms
Reference
AT+QCFG="gprsattach" GPRS Attach Mode Configuration
Write Command
AT+QCFG=“gprsattach”[,<attachmode
>]
Response
If <attachmode> is omitted, return current configuration:
+QCFG: “gprsattach”,<attachmode>
OK
If the configuration parameter <attachmode> is not omitted,
configure the GPRS attach mode:
OK