Quectel EC25

LTE Module Series
EC25&EC21 AT Commands Manual
EC25&EC21_AT_Commands_Manual 148 / 231
Parameter
10.3. AT+CGQREQ Quality of Service Profile (Requested)
The command allows the TE to specify the quality of service profile that is used when the MT activates a
PDP context.
The Write Command specifies a profile for the context <cid>. A special form of the Write Command,
AT+CGQREQ=<cid> causes the requested profile for context number <cid> to become undefined. The
Read Command returns the current settings for each defined context. Details can be found in 3GPP TS
23.107 and all parameters are saved in NV automatically.
<cid> PDP context identifier. A numeric parameter which specifies a particular PDP context
definition. The parameter is local to the TE-MT interface and is used in other PDP
context-related commands. The range of permitted values (minimum value=1) is
returned by the test form of the command.
<PDP_type> Packet data protocol type, a string parameter which specifies the type of packet data
protocol.
“IP” IPV4
“PPP”
“IPV6”
“IPV4V6”
<APN> Access point name, a string parameter that is a logical name used to select the GGSN
or the external packet data network. If the value is null or omitted, then the
subscription value will be requested.
<PDP_addr> A string parameter identifies the MT in the address space applicable to the PDP. If the
value is null or omitted, then a value may be provided by the TE during the PDP startup
procedure or, failing that, a dynamic address will be requested. The allocated address
may be read using the AT+CGPADDR command.
<data_comp> A numeric parameter that controls PDP data compression (applicable for SNDCP only)
(refer to 3GPP TS 44.065).
0 Off (Default if value is omitted)
1 On (Manufacturer preferred compression)
2 V.42bis
3 V.44 (Not supported currently)
<head_comp> A numeric parameter that controls PDP header compression (refer to 3GPP TS 44.065
and 3GPP TS 25.323).
0 Off
1 On
2 RFC1144
3 RFC2507
4 RFC3095