LTE Module Series
EC25&EC21 AT Commands Manual
EC25&EC21_AT_Commands_Manual 42 / 231
4.3.3. AT+QCFG="nwscanseq" Network Searching Sequence Configuration
The command specifies the sequence of searching network. This configuration is valid only after the
module is restarted.
Parameter
4 TD-SCDMA only
5 UMTS only
6 CDMA only
7 HDR only
8 CDMA and HDR only
<effect> Number format. When to take effect
0 Take effect after UE reboots
1 Take effect immediately
AT+QCFG="nwscanseq" Network Searching Sequence Configuration
Write Command
AT+QCFG=“nwscanseq”[,<scanseq>]
Response
If <scanseq> is omitted, return current configuration:
+QCFG: “nwscanseq”,<scanseq>
OK
If <scanseq> is omitted, specify the network searching
sequence:
OK
ERROR
If there is any error related to ME functionality:
+CME ERROR: <err>
<scanseq> Number format. Network search sequence
(e.g.: 04030201(LTE/WCDMA/TD-SCDMA/GSM))
00 Automatic (LTE/ WCDMA/TD-SCDMA/GSM)
01 GSM
02 TD-SCDMA
03 WCDMA
04 LTE
05 CDMA
To Next Page
Loading...
