Quectel EC25

LTE Module Series
EC25&EC21 AT Commands Manual
EC25&EC21_AT_Commands_Manual 46 / 231
4.3.7. AT+QCFG="hsdpacat" HSDPA Category Configuration
The command specifies the HSDPA category. This configuration is valid only after the module is restarted.
Parameter
4.3.8. AT+QCFG="hsupacat" HSUPA Category Configuration
The command specifies the HSUPA category. This configuration is valid only after the module is restarted.
1 Take effect immediately
AT+QCFG="hsdpacat" HSDPA Category Configuration
Write Command
AT+QCFG=“hsdpacat”[,<cat>]
Response
If <cat> is omitted, return the current configuration:
+QCFG: "hsdpacat",<cat>
OK
If <cat> is not omitted, configure the HSDPA category:
OK
ERROR
If there is any error related to ME functionality:
+CME ERROR: <err>
Maximum Response Time
300ms
<cat> HSDPA category
6 Category 6
8 Category 8
10 Category 10
12 Category 12
14 Category 14
18 Category 18
20 Category 20
24 Category 24
AT+QCFG="hsupacat" HSUPA Category Configuration
Write Command
AT+QCFG=“hsupacat”[,<cat>]
Response
If <cat> is omitted, return the current configuration:
+QCFG: "hsupacat",<cat>