LTE Module Series
EC25&EC21 AT Commands Manual
EC25&EC21_AT_Commands_Manual 74 / 231
6 Network Service Commands
6.1. AT+COPS Operator Selection
The command returns the current operators and their status, and allows setting automatic or manual
network selection.
AT+COPS Operator Selection
Response
TA returns a set of five parameters, each representing an
operator presenting in the network. Any of the formats may be
unavailable and should then be an empty field. The list of
operators shall be in the order of: home network, networks
referenced in (U)SIM and other networks.
+COPS: (list of supported <stat>,long alphanumeric <oper>,
short alphanumeric <oper>,numeric <oper>s)[,<Act>])s]
[,,(list of supported <mode>s),(list of supported <format>s)]
OK
If there is any error related to ME functionality:
+CME ERROR: <err>
Response
TA returns the current mode and the currently selected
operator. If no operator is selected, <format>, <oper> and
<Act> are omitted.
+COPS: <mode>[,<format>[,<oper>][,<Act>]]
OK
If there is any error related to ME functionality:
+CME ERROR: <err>
Write Command
AT+COPS=<mode>[,<format>[,<oper
>[,<Act>]]]
Response
TA forces an attempt to select and register the GSM/UMTS
network operator. If the selected operator is not available, no
other operator shall be selected (except <mode>=4). The
format of selected operator name shall apply to further Read
To Next Page
Loading...
Need help?
General
