<stat> 0 Unknown
1 Operator available
2 Current operator
3 Operator forbidden
<oper> Operator in format as per <mode>
<mode> 0 Automatic mode. <oper> field is ignored
1 Manual operator selection. <oper> field shall be present and <Act> optionally
2 Manually deregister from network
3 Set only <format> (for AT+COPS? Read Command), and do not attempt
registration/deregistration (<oper> and <Act> fields are ignored). This value is
invalid in the response of Read Command.
4 Manual/automatic selection. <oper> field shall be presented. If manual selection
fails, automatic mode (<mode>=0) is entered
<format> 0 Long format alphanumeric <oper> which can be up to 16 characters long
1 Short format alphanumeric <oper>
2 Numeric <oper>. GSM location area identification number
<Act> Access technology selected. Values 3, 4, 5 and 6 occur only in the response of Read
Command while MS is in data service state and is not intended for the AT+COPS Write
Command.
0 GSM
2 UTRAN
3 GSM W/EGPRS
4 UTRAN W/HSDPA
5 UTRAN W/HSUPA
6 UTRAN W/HSDPA and HSUPA
7 E-UTRAN
100 CDMA
To Next Page
Loading...
