LTE Module Series
EC25&EC21 AT Commands Manual
EC25&EC21_AT_Commands_Manual 155 / 231
Parameter
Write Command
AT+CGEQREQ=[<cid>[,<Traffic
class>[,<Maximum bitrate UL>
[,<Maximum bitrate DL>
[,<Guaranteed bitrate UL>
[,<Guaranteed bitrate DL>
[,<Delivery order>
[,<Maximum SDU size>
[,<SDU error ratio>
[,<Residual bit error ratio>
[,<Delivery of erroneous SDUs>
[,<Transfer delay>
[,<Traffic handling priority>
[,<Source statistics descriptor>
[,<Signalling indication>]]]]]]]]]]]]]]]
<cid> PDP context identifier, a numeric parameter which specifies a
particular PDP context definition. The parameter is local to the TE-MT
interface and is used in other PDP context-related commands. The
range of permitted values (minimum value=1) is returned by the test
form of the command
<PDP_type> Packet data protocol type, a string parameter which specifies the type
of packet data protocol
“IP” IPV4. Internet protocol (IETF STD 5)
“PPP”
“IPV6”
“IPV4V6”
The following parameters are defined in 3GPP TS 23.107
<Traffic class> Integer type. Indicates the type of application for which the UMTS
bearer service is optimized (refer to 3GPP TS 24.008 subclause
10.5.6.5). If the parameter is specified as conversational or streaming,
then the Guaranteed and Maximum bitrate parameters should also be
provided.
0 Conversational
1 Streaming
2 Interactive
3 Background
To Next Page
Loading...
