“LTE”
“TD-SCDMA”
“CDMA”
“HDR”
“EVDO”
“UNKNOWN”
The examples of URC are as below:
+QIND: "act","HSDPA&HSUPA"
+QIND: "act","UNKNOWN"
The description of “act” is as below:
1. If module does not register on network, the
<actvalue> would be “UNKNOWN”.
2. If this configuration is ON, the URC of "act" will be
reported immediately. Only when the network
access technology changes, a new URC will be
reported.
<enable> URC indication is ON or OFF
0 OFF
1 ON
<savetonvram> Whether to save configuration into NV. Not saved by default.
0 Not save
1 Save
To Next Page
Loading...
