Safety Warnings and Precautions
110 Kiaro! 50 User Guide
• Labels printed with this printer should not directly be stuck on food such as fruits
and vegetables. They should be stuck on the plastic wrap over the food.
Important
• To prevent machine failures, do not open the ink tank door or transport unit, do not
turn off the printer, and do not remove the power plug from the outlet while the
printer is printing. If you do so, the print head protection function is not performed
properly, resulting in a machine failure or ink leakage which can soil your clothes
and the surrounding area.
• Do not place the printer close to TV, radio receiver or loudspeakers, etc. The
magnetic field produced may cause the printer to malfunction, or the printer may
interfere with TV/radio reception.
• Printed labels and ink can discolor due to ultraviolet rays and ozone.
Moving the Printer
Warning
• Call the dealer for advice before you ship the printer a long distance or move the
printer by car or truck where it may be subjected to shock and vibration. Moving the
printer without the proper preparation could subject it to shocks and vibrations
which could damage the printer and cause a fire.
Caution
• Before moving the printer, use the appropriate procedures to drain ink from the
printhead or entire print system. See “Preparing for Moving” on page 62. See
“Preparing for Shipping” on page 62.
• Before you move the printer to another location in the same building, disconnect
the power cord and make sure that all other cables are disconnected.
• When carrying the printer, be sure to hold it at the bottom with both hands so that
it does not fall down.
• Always hold the printer level and carry it slowly. If ink is spilled inside the printer
while moving it, this could cause a fire or serious electrical shock or damage the
printer.
Important
To Next Page
Loading...
Need help?
General
