23
Video Playback Interface
Moon Exclusion Search On Playback
In order to recognise incidents of acvity upon the camera’s
video footage, with even greater eciency, we have included a
moon exclusion tool.
This tool allows you to select areas of the video footage, from
each individual camera, to exclude any moon detecon pickup
to be displayed on the me line.
To set the moon exclusion sectors on each camera; click the
right mouse buon when the cursor is above the me line
secon of the playback interface. The opon panel will appear,
and you will need to select ‘Select Regions of Interest’ as shown
to the right in the red box.
The panel below will then appear. If you click on a square le it will highlight in red.
The selected red les are used to mark the area that you would like to be excluded from a
recording even if moon is detected.
You can bring down a list of all the connected cameras from the tab at the top of this
window.
When you have completed creang your exclusion areas, click ‘Apply’ and then click ‘Close’
to switch back to the main playback interface.
Red = Excluded motion area
To Next Page
Loading...
Need help?
General
