118
Menu Reference
LMIT
Parameter
Options Description
Fav Yes or No When On, the LMIT object
is a member of the Favorites
Scan List.
EXPERT BELOW
Modulation Auto,
AM,
FM,
NFM
Modulation setting for the
LMIT search. In most cases
Auto will work fine. Use AM
to override and force AM
modulation, FM to force FM
modulation, NFM to force
narrow FM modulation.
Atten On or Off When on, applies 20 dB of at-
tenuation to all hits received
on the LMIT search. Useful
in areas where interference
from nearby strong signals is
present.
Delay On or Off Controls whether a Delay is
used to wait for reply traffic
after a transmission is received
during the LMIT search.
Delay Time 1-250 x
100 ms
Sets the amount of time (in
100 millisecond intervals) for
the wait for reply delay if Delay
is On, e.g., 20=2 seconds.
Zeromatic On or Off When on, enhances the
scanner’s ability to lock on to
the actual center frequency of
a search hit instead of an adja-
cent frequency.
Search Dir Up or
Down
Sets search direction used
when LMIT object is active.
Hit Count Numeric
value
Increments each time a
transmission is received on
the LMIT object. Global “Hit
Counts” must be set to ON.
Press the
Dflt softkey to
reset to 0.
To Next Page
Loading...
