44
• You can designate any of your scanner’s banks as
either a trunk scanning bank or conventional scan-
ning bank, but you cannot mix the two modes in
one bank.
• The PRO-94 can scan multiple trunking systems. if
a system is inactive for 5 seconds, the PRO-94
starts scanning the next selected trunk bank.
Follow these steps to select, program, and store trunk-
ed frequencies.
1. Press
PROG
then
TRUNK
.
TRUNK
appears and
one or more bank numbers flash.
2. Press the number key (1–10) of the desired target
storage bank. Select one of the trunk systems by
repeatedly pressing
W
or
V
to select a trunking
system type, then press
E (SVC)
. The scanner then
automatically selects the first channel in the
selected bank.
Note:
You can select from the following six sys-
tems :
3. Use the number keys to enter a valid frequency
within the trunk system, then press
E (SVC)
.
BANK
and the bank number, the channel number, and
E
(EDACS) or
M
(Motorola) appears depending upon
the trunk system selected.
You See Trunk System
E1
Motorola Type I, 800 MHz fre-
quencies
Ed
EDACS frequencies
E2
–
800
Motorola Type II, 800 MHz fre-
quencies
E2
–
900
Motorola Type II, 900 MHz fre-
quencies
E2
–
Hi
Motorola Type II, VHF frequen-
cies
E2
–
UHF
Motorola Type II, UHF frequen-
cies
20-524.fm Page 44 Tuesday, August 31, 1999 3:55 PM
To Next Page
Loading...
