45
Notes:
• If you enter an invalid frequency (outside the
selected range), the scanner beeps, the channel
number flashes and
Error
appears. If this
happens, press
MON/CLR
(
•
) to clear the fre-
quency, then repeat the entry.
• For EDACS systems, you must enter the fre-
quencies in logical channel number (LCN) order.
• If you try to enter a duplicate frequency in a
bank, the scanner beeps and the channel which
was previously stored appears.
• It is very important that you enter all the listed
frequecies for the selected agency in Step 3.
Otherwise, trunking will not occur when you
press
SRC (see Step 6)
.
4. Press either
PROG
or
V
to select the next channel
in the bank.
5. Repeat Steps 3 and 4 until you enter all desired
frequencies in that bank.
6. Press
SRC
to begin searching for the trunk’s data
channel (the channel that controls the trunk).
SEARCH
flashes as the scanner searches for the
data channel.
As
the scanner looks through the frequencies, you
see them on the display. When the scanner finds
the controlling data channel, the scanner begins
trunking.
20-524.fm Page 45 Tuesday, August 31, 1999 3:55 PM
To Next Page
Loading...
