Radiodetection RD1500 - Page 72

Transferring Data to a PC
© Radiodetection 2016 67 RD1500 Operation Manual
Alternatively, if you want to export the data later, you can select No. Later, when you are ready
to export your data, select Setup > File Management from the main menu and press Export
Data (Section 13)
The directory structure on the USB drive can be viewed on your PC, and will look as follows:
 GPR Data
 RD1500
o Export01
 Project1
 Screen Shots
o All Screenshots as .JPG files
 Project1.GPZ file
 Project1.KMZ file
 Field Interp Report.CSV
 Project2
 Screen Shots
o All Screenshots as .JPG files
 Project2.GPZ file
 Project2.KMZ file
 Field Interp Report.CSV
 System Info
o Exportxx
 Projectx
 Screen Shots
o All Screenshots as .JPG files
 .GPZ file
 .KMZ file
 Field Interp Report.CSV
 System Info
All screenshot files are saved as .JPG files
The actual GPR data files are all contained in a .GPZ file. This can be opened by the
EKKO_Project software.
If data was collected with GPS (internal or external), a .KMZ file is also generated. This contains
positional information and can easily be opened in Google Earth
TM
.
If any Interpretations were made, these are saved in a .CSV file. This is a spreadsheet file,
which shows the positional information of any interps made.
The System Info folder contains log files and a system summary diagnostic report.
Each successive export of data will create a new directory called ExportXX, where XX is
incremented by 1 from the previous directory.