RadioLink AT10 - gyro mixing; Gyro operation modes; Gain Example for AVCS;Heading-hold Gyros (GY)

57
Gyro gain adjustment:
• When the servo hunts, the gyro gain is too high. Lower the gain until the hunting stops.
7KH J\UR ZLOO GLVSOD\ EHVW SHUIRUPDQFH DW D JDLQ MXVW EHIRUH KXQWLQJ RFFXUV 3HUIRUP DGMXVWLQJ E\ À\LQJ WKH DLUFUDIW
repeatedly.
Precautions:
• When taking off and landing, always switch to the Normal mode. Taking off and landing in the GY mode is dangerous.
• We recommend that you use the rudder control gyro in the Normal mode. In the GY mode, rudder operation is
necessary when turning because the weathervane effect is lost. Use the gyro in the Normal mode unless you are an expert
in rudder operation.
• And we recommend that you also set to off (0%) mode for safety as follows.
GOAL of EXAMPLE: STEPS: INPUTS:
Set up a gyro setting. (Ex: MIX-1) Open and activate the
GYRO SENSE
function.
for 1 second.
(If
BASIC
, again.)
C
to
GYRO SENSE
.
Activate the function.
C
to
MIX-1
. to
ON
.
Optional: change switch assignment.
Ex: select
E
.
C
to
SW
to
E
.
Adjust gyro rates as needed. (Ex:
UP
to
NOR70%
,
CNTR
to
0% (off)
,
DOWN
to
AVC70%
as starting points.)
C
to gyro rate
E up. to
NOR 70%
.
(
0%
).
E down. to
AVC 70%
.
Close menu.