or on its completion.
The measuring units are previewed by pressing DISPLAY key.
Each pressing of the key changes in turns the measuring unit
and automatic recalculation of measurement result. Available
measuring units:
%M (percent loss of mass in tested sample);
%D (dry mass in tested sample);
%R (humid / dry ratio expressed in %);
A chart from drying process
Mass loss in tested sample in [g]. .
Additionally, the display of MAX series contains the following:
drying time, current temperature in drying chamber, drying
mode, target (set) temperature, drying process result in a form
of: %M; %D; %R; chart, mass loss in [g].
Changes made to software settings are effective only on exiting to main
menu with procedure of saving changes.
On making all changes in the parameter settings, exit to main menu by pressing the
ESC key for a few times, until the software displays a message box with below two
option:
ENTER – save changes and exit
ESC – abandon changes and exit
To Next Page
Loading...
